This is the authors' abstract. We don't add key points for this paper.
Melt viscosities were measured on 25 narrow molecular weight distribution (anionically polymerized) and 7 broad distribution (isothermally polymerized) polystyrenes ranging in molecular weight from 50,000 to 570,000. Measurements were made at temperatures between 200 and 250°C. and at shearing stresses of 120,000–1,400,000 dynes/cm.2 using a capillary‐type viscometer. Zero shear viscosity and non‐Newtonian constant was found to depend upon weight‐average molecular weight while high shear viscosity was found to depend upon some molecular weight between weight average and number average. Analysis of flow curves for two materials having the same zero shear viscosity but different weight average‐number average ratios indicated that the narrow distribution material had a higher high shear viscosity than the broad material pointing to lessened ease of fabrication. From flow data at different temperatures, apparent activation energies were calculated. Apparent activation energy was found to be independent of molecular weight above a molecular weight of 50,000 and to decrease slightly with increasing M̄w/M̄n ratio. The effects of plasticization and blending upon flow properties were also studied using samples to which 1% mineral oil had been added and blends of high and low molecular weight narrow distribution polymers.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
J. F. Rudd (1960) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: