Answers are grounded in this paper and cite their sources.
Optimal laser scanning parameters to densify commercial-purity aluminum, fabricated using selective laser melting (SLM), were studied using an SLM machine equipped with a 400 W Yb fiber laser. The SLM samples with a relative density of 99.7% were obtained. The microstructures and the thermal and mechanical properties of the dense SLM samples fabricated using the optimal laser scanning parameters were investigated. The as-fabricated SLM samples had granular microstructures of aluminum, silicon, and/or iron oxides dispersed finely (~0.3 μm) due to the rapid solidification by laser irradiation. The mechanical properties were thus confirmed to be excellent (ultimate tensile strength: 110 MPa, proof stress: 90 MPa, breaking elongation: 30%). The thermal conductivity of the SLM sample was approximately 200 W/m·K, which was slightly inferior to that of the wrought commercial-purity aluminum (230 W/m·K). The effect of annealing on the properties of the SLM samples were also investigated. The thermal conductivity of the SLM sample annealed at 450℃ for 10 minutes increased to the same value as that of the wrought commercial-purity aluminum, although both the proof stress and breaking elongation were slightly decreased.
No takes yet. Share an insight, caveat, or question.
Kimura et al. (2017) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: