Answers are grounded in this paper and cite their sources.
A technique has been developed for studying polyethylene with the Spinco Model E analytical ultracentrifuge. 1‐Chloronaphthalene at 120°C. is used as the solvent. A variety of whole polymers from several sources was studied and found to differ considerably in the distribution of their sedimentation rates. Most of the low‐density polyethylenes exhibited a high molecular weight tail (that is, a fast‐moving fraction), whereas a high‐density sample showed a low molecular weight tail. In general, the ultracentrifuge Schlieren patterns showed a direct correlation with light‐scattering results—polymers with high weight‐average molecular weights showed broad patterns containing fastmoving tails. There was also a direct correlation between broad patterns and high values for the Flory expansion factor, α. An exception to the agreement between high weight‐average molecular weight and broad Schlieren pattern was found for a sample (B‐1) which was shown by electron microscopy to have very large molecules present in its make‐up. These large molecules, because of their size, greatly influence the light scattering measurements but, because they were present in relatively small numbers, they were not observed in the Schlieren pattern. A number of fractions were also investigated. The Schlieren patterns obtained with fractions prepared by the Guillet et al. adaptation of the chromatographic method of Baker and Williams were sharper than those obtained with fractions prepared by the extraction method of Desreux and Spiegels. Estimates of the degrees of long‐chain branching were made from measurements of intrinsic viscosities and sedimentation rates of fractions. A knowledge of the molecular weight is not required for this estimate; therefore, this method has some advantage over the older method involving light scattering measurements. There is an excellent correlation between the number of branches per molecule and the intrinsic viscosity for a number of fractions obtained from a low‐density polyethylene of broad distribution. This result is predicted from the theoretical considerations of Beasley. It was also found that fractions from polyethylenes of narrower distribution contained fewer branches per molecule than fractions of comparable intrinsic viscosity from a polymer of broader distribution. This result confirms Beasley's theory that the long‐chain branching mechanism is responsible for the broad molecular weight distributions in low‐density polyethylenes. These differences in branching and molecular weight distribution are most likely responsible for many of the differences in behavior among various polyethylenes.
No takes yet. Share an insight, caveat, or question.
Moore et al. (1962) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: