This is the authors' abstract. We don't add key points for this paper.
This study compares the performances of twelve regional chemical transport models (CTM) from the third phase of Model Inter-Comparison Study for Asia (MICS-Asia III) on simulating the particulate matter (PM) over East Asia (EA) in 2010. The participating models include WRF-CMAQ (v4.7.1 and v5.0.2), WRF-Chem (v3.6.1 and v3.7.1), GEOS-Chem, NHM-Chem, NAQPMS and NU-WRF. Evaluations with ground measurements and satellite data show that the mean biases of multi-model mean (MMM) are −25 µg m−3 (−30 %), −7 µg m−3 (−15 %). −0.7 µg m−3 (−19 %), −0.05 µg m−3 (−3 %) and 0.1 µg m−3 (12 %) for surface PM10, PM2.5, SO42−, NO3− and NH4+ concentrations, respectively. This study investigates four model processes as the possible reasons for different model performances on PM: (1) Using different natural emissions (i.e. dust and sea-salt emissions) brings upmost 0.25 µg m−3 (70 %) of inter-model differences to domain-average black carbon concentrations at surface layer and 756 ppb (22 %) of inter-model differences to domain-average CO column. Adopting different initial/boundary conditions results in 10–20 % differences in PM concentrations in the center of the simulation domain. (2) Models perform very differently in the gas-particle conversion of sulphur (S) and oxidized nitrogen (N). The model differences in sulphur oxidation ratio (50 %) is of the same magnitude as that in SO42− concentrations. The gas-particle conversion is one the main reasons for different model performances on fine mode PM. (3) Models without dust emissions/modules can perform well on PM10 at non-dust-affected sites, but largely underestimate (upmost 50 %) the PM10 concentrations at dust sites. The implementation of dust emissions/modules in models has largely improved the model accuracies at dust sites (reduce model bias to −20 %). However, both the magnitudes and distributions of dust pollutions are not fully captured. (4) The amounts of modelled depositions vary among models by 75 %, 39 %, 21 % and 38 % for S wet, S dry, N wet and N dry depositions, respectively. Large inter-model differences are found in the washout ratios of wet deposition (at most 170 % in India) and dry deposition velocities (general 0.3–2 cm s−1 differences over inland regions). This study investigates the reasons for different model performances on PM over EA and offers suggestions for future model development.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Tan et al. (2019) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: