Answers are grounded in this paper and cite their sources.
This paper proposes an electrochemical etching technique to fabricate tungsten tips. Tips combining well-defined conical shape, a length as large as 2 mm, and sharpness with a radius of curvature of around 20 nm are fabricated using the proposed technique. These tips are needed in a variety of applications including multipoint contact measurements and nanomanipulation. The technique consists of three steps: the first is static etching, which creates a neck-in phenomenon on the wire; the second is dynamic etching, where the wire is oscillated up and down in the solution to form a long conical shape; finally, static etching is applied again to break the wire, and thus, sharp tips are produced. The best operating conditions of the process were experimentally obtained. These factors include the position of the cathode, the length of the immersed wire, and the applied voltage. The effects of these factors on the etching current and tip fidelity were also examined based on the measured etching current. In particular, the position of the cathode determines the strength of the electrical field near the air/solution interface; the immersed wire depth determines mainly the equivalent resistance of the process and thus controls the etching current; and the applied voltage defines the etching rate of the wire.
No takes yet. Share an insight, caveat, or question.
Milhim et al. (2014) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: