Answers are grounded in this paper and cite their sources.
In present article, influence of grain refinement (Al5Ti1B) on the morphology of iron-rich β-phase intermetallic compounds in Al-12Si-Cu-Mg alloy having two addition levels of iron as alloying element has been reported. The mechanical properties such as tensile strength and ductility of base alloy and the grain refined alloys were measured. The effect of grain refiner on quality index of the alloys on the basis of mechanical properties was also assessed. It was observed that the higher iron content in an alloy results in coarser iron-rich β-phase intermetallic compounds in more quantity than low iron content alloy. The addition of grain refiner in an alloy modifies the distribution of iron-rich intermetallic compounds and changes their morphology from needle to blocky and Chinese script form besides reducing their average length and aspect ratio, which in turn improves the mechanical properties significantly. Further, it was observed that alloy with high iron (2.68 wt%) content required more quantity of grain refiner for better refinement and mechanical performance than the alloy with low iron content. Addition of grain refiner also increased the quality index of the low level iron alloy by about 50%, while that in case of high level iron alloy increased up to 136%.
No takes yet. Share an insight, caveat, or question.
Rodríguez et al. (2011) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: