Answers are grounded in this paper and cite their sources.
The elastic constants are determined from bending and torsion experiments on single crystal rods. It is shown that for each crystal orientation there is a definitely limited region of proportionality between an initially increasing stress and the corresponding strain. The elastic region is a minimum (and very small) for crystals of 45^∘{} orientation. Elastic hysteresis occurs for bending but not for torsion, except for previously permanently strained crystals. There is no permanent set for stresses within the elastic limit. Two slightly different grades of very pure (99.99+percent) zinc are studied. Their elastic behavior is in general alike, but the elastic constants differ appreciably. The constants found are: for Evanwall zinc, S₁₁=8.08; S₁₂=1.57; S₁₃=-7.85; S₃₃=26.28; S₄₄=25.15; for Horsehead Special zinc, S₁₁=7.70; S₁₂=0.45; S₁₃=-6.39; S₃₃=27.66; S₄₄=24.40, all times 10^-13 cm²/dyne. The single crystal form possesses a definite and reproducible elastic behavior in contrast with the puzzling and variable results obtained for the polycrystalline and technically usable material.
No takes yet. Share an insight, caveat, or question.
Alvin W. Hanson (1934) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: