Answers are grounded in this paper and cite their sources.
This paper describes the improvement of characteristics of an offset tri‐reflector antenna by introduction of reflector surface shaping, and the importance and allowance of suppression of the higher periodic components of the reflector surface distortion caused in the fabrication process. In an antenna with a good wide‐angle radiation pattern, degradation of the sidelobe characteristics due to the higher‐order periodical components of the surface distortion cannot be taken lightly. In this paper, the angle and the level of the side‐lobe peak due to the periodic aperture phase error are expressed in simple formulas. These formulas are combined with an approximate expression of the wide‐angle radiation pattern so that the allowance of the periodic reflector surface distortion is given. Next, a design and measured characteristics are described for a shaped offset tri‐reflector antenna with its aperture diameter of 3600 mm to be used at frequencies of 3.6 to 6.475 GHz. Two prototypes with difference values of surface accuracy are compared. By means of measured examples, it is pointed out that suppression of higher‐order periodic components of the surface distortion is important. By means of reflector shaping, a nonaxisymmetric aperture distortion is important. By means of reflector shaping, a nonaxisymmetric aperture distribution is realized so that the edge level in the horizontal cross section is made small. Further, by suppressing the higher‐order periodic components of the surface distortion, an offset tri‐reflector antenna with a good wide‐angle pattern and a good cross‐polarization characteristic was realized.
No takes yet. Share an insight, caveat, or question.
Karikomi et al. (1991) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: