Answers are grounded in this paper and cite their sources.
A method for rapid determination of the nonuniformity coefficient, Mw/Mn, of linear polyethylenes and crystalline polypropylenes is described. The number‐average molecular weight Mn was determined by counting the number of C14‐labeled alkyl groups introduced into the polymers during the initiation step. The weight‐average molecular weight Mw was calculated from viscometric data. The errors in these calculations were estimated. The values of Mw/Mn thus obtained for eleven samples of linear polyethylenes and three samples of crystalline polypropylenes are compared with the corresponding results obtained by polymer fractionations. The agreement was good for all the polyethylene and polypropylene samples studied except for three high viscosity polyethylene samples with high Mw values and low Mn values from fractionation data. The Mw/Mn values were determined for polymer samples taken during ethylene polymerizations initiated by the (C5H5)2TiCl2–(CH3)2AlCl system. This ratio at first decreased with the polymerization time, then reached a minimum as the concentration of growing chains reached a maximum. Comparison of polyethylene produced at various temperatures reveals that the width of polymer distribution decreases with rising polymerization temperatures. This decrease is attributed to the increase in the rates of initiation and termination and the higher activation energy for the termination processes. High catalyst concentrations yielded polyethylenes of broad distributions. At high catalyst concentrations, the concentrations of growing chains are also high. Consequently, more low molecular weight chains terminate early to give products with large Mw/Mn. On the other hand, increase of the Al/Ti ratio increases chain transfers giving polyethylenes having a low Mw/Mn. An additional effect of increasing the Al/Ti ratio is the decreased variation of Mw/Mn with t. The Mw/Mn values of crystalline polypropylene samples taken during polymerizations initiated by α‐TiCl3‐(C2H5)2AlCl are also presented. They were high at the beginning of the polymerizations and decreased gradually to a lower constant value. At higher temperatures, this variation was less pronounced; and the Mw/Mn values were lower than those for the polymers obtained at lower temperatures. The Mw/Mn values were insensitive to experimental variables such as the catalyst concentrations, the Al/Ti ratios, and the monomer pressures in agreement with the kinetic results. The Mw/Mn values of amorphous polypropylene samples taken during propylene polymerizations did not vary with t or with the other polymerization conditions. These results support the earlier kinetic interpretation that extensive chain transfers occur during the formation of amorphous polypropylenes.
No takes yet. Share an insight, caveat, or question.
James C. W. Chien (1963) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: