Answers are grounded in this paper and cite their sources.
This study reports, for the first time, the development of a permanent load-bearing biomedical device - a dental implant (DI) - fabricated from a partially bioresorbable Ti–Mg metal–metal composite. The Ti+17 vol%Mg (Ti17Mg) composite was produced via powder metallurgy hydrostatic extrusion process, and its mechanical properties were optimized through post-thermal treatment. The resulting microstructure consisted of a network of bioabsorbable Mg filaments embedded within a permanent ultrafine-grained Ti matrix. The Young's modulus of Ti17Mg was approximately 20 % lower than that of commercially pure Ti Grade 4 (TiGR4), while its tensile properties satisfied the requirements for implant materials. DIs were CNC-machined from the heat-treated Ti17Mg using two design concepts - conventional and integrated. Their mechanical performance was modeled and experimentally evaluated according to the fatigue testing protocol for endosseous DIs, following 7 days of pre-corrosion in physiological solution. Mg degradation from the DI's surface was quantified using the H 2 evolution method. The in-vitro biological response was assessed using three indirect assays -end-point metabolic activity, end-point cell stress, and continuous cell proliferation - performed with cell culture media extracts of the DIs. The results, benchmarked against TiGR4 DIs, demonstrated that the integrated Ti17Mg DI meets mechanical and in-vitro biological standards, while exhibiting enhanced osteoinductive potential, improved bone-implant interfacial bonding, and reduced stress-shielding. These findings identify Ti17Mg as a promising alternative material for permanent load-bearing DIs.
No takes yet. Share an insight, caveat, or question.
Balog et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: