Answers are grounded in this paper and cite their sources.
Single-pole writers and tunneling magnetoresistive (TMR) readers for 140-Gb/in/sup 2/ perpendicular recording were fabricated and their recording performance was tested. Data erasure, which is observed as write instability in a repeated read-write operation, can be suppressed by combining a laminated pole and low throat height. Fe-Co/Ni-Cr laminated film was used to reduce the remanent magnetization of the main pole after patterning. Narrow track writers with a 120-nm-wide trapezoidal pole showed a good write ability of 30 dB or more in overwrite for media with high coercivity of up to 7 kOe. Also, negligibly small skew writing was confirmed. TMR heads with a sensor width of 85 nm and a head resistance of 250 /spl Omega/ showed approximately 30 dB of head signal-to-noise ratio (SNR). A potentially higher SNR with a higher operating voltage was suggested from a measured output versus sensing current curve. Calculations showed that the side reading was suppressed in a side-shielded design. A 10% amplitude width of the microtrack profile of a 100-nm-wide reader was reduced from 198 to 162 nm by applying the side shields.
No takes yet. Share an insight, caveat, or question.
Nakamoto et al. (2004) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: