Answers are grounded in this paper and cite their sources.
Current thermal barrier coatings (TBCs), typically made of yttria-stabilized zirconia (YSZ), face challenges in the high-moisture, high-temperature environment during the combustion of hydrogen-enriched fuels. This is mainly due to YSZ's high ionic conductivity facilitating moisture transfer through the YSZ layer toward the underlying substrate. In this study, a thin alumina layer, deposited by atomic layer deposition (ALD), was added to the YSZ coating, and the effect of the ALD-alumina layer on the moisture resistance properties of YSZ coatings was investigated in the hydrogen-enriched flame zone of a swirl combustor. Three different coating configurations were prepared: YSZ-alone, YSZ with an alumina layer beneath it (YSZ/alumina), and YSZ with an alumina layer on top (alumina/YSZ). At 430 °C, the ionic conductivity of the YSZ/alumina and alumina/YSZ coatings was measured to be 4.33×10−6Sm−1 and 1.34×10−7Sm−1, respectively, which was 4–5 orders of magnitude lower than that for the YSZ coating. These coatings were tested in the flame zone with a temperature of 1248–1260 °C and a moisture concentration of about 18.1% for 15 min in the swirl combustor. Compared to the baseline YSZ-alone coating, the growth in thickness of the interfacial oxidation layer near the substrate was reduced by a factor of >2 for the YSZ/alumina coating and by a factor of >8 for the alumina/YSZ coating. The result showed that the thin ALD-alumina layer effectively acted as a barrier to moisture diffusion, primarily due to its extremely low ionic conductivity.
No takes yet. Share an insight, caveat, or question.
Shen et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: