Answers are grounded in this paper and cite their sources.
The increasing dissemination of antibiotic-resistant bacteria in agricultural regions represents an environmental and public health problem. Chitosan, a natural biopolymer derived from chitin, has attracted interest due to its intrinsic antimicrobial activity, biocompatibility, and ability to form nanometer-scale structures, which promote interaction with microbial cells [1,2]. In zones with intensive use of agrochemicals, such as Uruapan in the state of Michoacán, Mexico, contaminated water bodies harbor bacterial reservoirs of strains with resistance mechanisms acquired by continuous exposure to agrochemical residues. This type of community usually presents high tolerance to chemical contaminants and antibiotics due to chronic selective pressure [3], which converts these microorganisms into potential models to evaluate new antimicrobial strategies. In this context, in the present study chitosan nanoparticles (ChNPs) were synthesized by the ionic gelation method. These ChNPs were characterized by scanning electron microscopy (SEM) and Fourier transform infrared spectroscopy (FTIR). The morphological analysis by SEM showed quasi-spherical nanoparticles with a tendency to agglomeration (Figure 1). The preliminary estimation of size, carried out by ImageJ and excluding agglomerated structures, indicated dimensions of approximately ∼50–120 nm, with greater frequency in the range of 70 to 90 nm, which agrees with nanometric chitosan systems previously reported [4]. The chemical characterization by FTIR spectroscopy (Fig. 2) confirmed the presence of characteristic chitosan bands corresponding to C–N bonds (1625 and 1528 cm−1), C–O–C vibrations (∼1150 cm−1), C–O stretching (1049–1020 cm−1), acetyl groups (1381 cm−1), and C–H bonds (∼2921 cm−1)[4]. The chitosan nanoparticles were dispersed in sterile distilled water to obtain stock solutions, and the final concentrations prepared were 5, 10, and 20 µg/mL. Subsequently, their antimicrobial effect and siderophore production were evaluated in a bacterial strain isolated from water bodies tributary to the Río Cupatitzio, in the city of Uruapan, Michoacán (19.384573, −102.062050). The strain presented bacterial populations with predominantly bacillary morphologies, observed by optical microscopy at 100× (Fig. 3), which is typical of bacterial communities of water bodies disturbed by agricultural activity. For the assays, the bacteria were inoculated in test tubes containing 4.5 mL of sterile nutrient medium, to which 0.5 mL of the ChNP solutions were added to reach a final volume of 5 mL. As positive control, commercial gentamicin at 0.2% (2 mg/mL) was added, incorporating 25 µL per tube to obtain a final concentration close to 10 µg/mL [5], while the negative control consisted of bacterial cultures without treatment. All cultured plates were incubated for 24 h at 28°C under static conditions. To evaluate the effect of ChNPs on microbial biomass, the bacterial cultures in nutrient medium were homogenized by applying vortex pulses and were directly transferred to cuvettes for spectrophotometric analysis. The results showed a decrease in bacterial biomass dependent on concentration in the treatments with exposure to ChNPs, evidencing an antimicrobial effect. Although gentamicin presented the greatest inhibition of growth, the highest concentration of ChNPs showed an equivalent effect, according to the statistical analysis. Total siderophore production was subsequently quantified by spectrophotometric analysis with Fe(NO₃)₃ according to the Arnow method at 10 mM [6]. Both the treatments with ChNPs and with gentamicin presented an increase in siderophore production with respect to the bacterial control, but not among treatments, which is consistent with antimicrobial stress response mechanisms, since siderophore overproduction constitutes an adaptive mechanism that favors iron capture under conditions of chemical stress and cellular damage [7,8]. The siderophore levels observed with gentamicin were similar to those obtained with 20 µg/mL of ChNPs, indicating that the nanoparticles induce metabolic responses comparable to those of a conventional antibiotic (Fig. 4). As a whole, the results demonstrate that chitosan nanoparticles effectively inhibit the growth of environmentally resistant bacteria and induce metabolic responses associated with stress, such as the increase in siderophore production. This multifactorial effect suggests mechanisms of action that include membrane alterations and limitation of essential nutrients [1,5]. The ChNPs are positioned as a promising and sustainable alternative for the control of resistant microorganisms in environmental systems impacted by agricultural activities [8]. SEM micrograph of chitosan nanoparticles showing quasi-spherical morphology. The nanoparticles showed a diameter of 70 to 90 nm range, indicated by the red lines. Scale bar = 1 µm. FTIR spectrum of chitosan nanoparticles. The characteristic bands of chitosan nanoparticles are observed with their characteristic wavelengths. Antibacterial effect of chitosan nanoparticles (ChNPs) after 24 h incubation in nutrient broth. (A) Representative Gram-stained smear (safranin) observed at 100× magnification (oil immersion), showing rod-shaped bacterial cells. (B) Bacterial cultures under different treatments. C, untreated control, G, gentamicin, 5, 10, and 20 µg/mL ChNPs. Effect of chitosan nanoparticles on a bacterial strain isolated from a water body exposed to agrochemicals. A) Effect of ChNPs on bacterial biomass at concentrations of 5, 10, and 20 µg/mL, including a positive control with gentamicin at 10 µg/mL. B) Total siderophore production of the bacterial strain under the same treatments. Bars represent standard deviation. Different letters indicate significant differences according to ANOVA/Tukey (p < 0.05).
No takes yet. Share an insight, caveat, or question.
Rangel-García et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: