Answers are grounded in this paper and cite their sources.
Background Nanoparticle load may interfere with the viscosity of the composites, challenging the printability in vat-polymerization techniques. This study aimed to evaluate the influence of silica nanoparticle addition on the physicochemical properties of a 3-dimensional (3D)-printed resin-based composite (RBC). Methods The resinous matrix of the experimental 3D RBC was kept fixed with the addition of silica nanoparticles (Aerosil OX50; Evonik), which were surface-treated with 3-(trimethoxysilyl) propyl methacrylate and used as fillers at 5 wt% (silicon dioxide [SiO 2 ] 5%), 10 wt% (SiO 2 10%), and 20 wt% (SiO 2 20%). The composite's viscosity was evaluated before printing. Specimens were 3D printed (Anycubic Photon Mono 4K 3D Printer; Anycubic Inc), cleaned with 96% ethanol, and postcured (Form Cure; Formlabs) at 60 °C. Specimens were evaluated for their radiopacity, polymerization kinetics, and degree of conversion. The flexural strength was assessed after 24 hours and 14 days of water storage. Results Silica nanoparticles were a median size of 65 nm (d 10 : 35 nm; d 90 : 129 nm). The addition of silica nanoparticles resulted in a 2-fold increase in the resin viscosity, without modifying the specimens' radiopacity. All groups presented more than 80% degree of conversion, but a faster polymerization with higher polymerization rates was observed for the SiO 2 5%. Despite the increased immediate flexural strength (mean [SD], 81.78 [3.14] MPa) shown by SiO 2 20%, the strength was reduced for all experimental groups after 14 days in water. Conclusions Increasing concentrations of silica nanoparticles increased 3D RBC properties. However, after 14 days of water storage, decreased flexural strength was observed.
No takes yet. Share an insight, caveat, or question.
A 2025 study studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: