Answers are grounded in this paper and cite their sources.
OBJECTIVE: To evaluate the effects of pilot hole diameter and tapping on insertion torque and axial pullout strength of 4.0-mm cancellous bone screws in a synthetic canine cancellous bone substitute. SAMPLE: 75 synthetic cancellous bone blocks (15 blocks/group). PROCEDURES: For groups 1 through 5, screw size-pilot hole diameter combinations were 3.5-2.5 mm (cortical screws), 4.0-2.5 mm, 4.0-2.5 mm, 4.0-2.0 mm, and 4.0-2.0 mm, respectively. Holes were tapped in groups 1, 2, and 4 only (tap diameter, 3.5, 4.0, and 4.0 mm, respectively). One 70-mm-long screw was inserted into each block; in a servohydraulic materials testing machine, the screw was extracted (rate, 5 mm/min) until failure. Mean group values of maximum insertion torque, axial pullout strength, yield strength, and stiffness were determined. RESULTS: Mean maximum insertion torque differed significantly among the 5 groups; the group 5 value was greatest, followed by group 3, 4, 2, and 1 values. Group 3, 4, and 5 axial pullout strengths were similar and significantly greater than the group 2 value; all values were significantly greater than that for group 1. Group 5 and 4 yield strengths were similar and significantly greater than the group 3, 2, and 1 values. Stiffness in group 3 was similar to group 4 and 2 values but significantly greater than the group 5 value; all values were significantly greater than that for group 1. CONCLUSIONS AND CLINICAL RELEVANCE: These synthetic cancellous bone model findings suggested that tapping a 2.0-mm-diameter pilot hole when placing a 4.0-mm screw is the optimal insertion technique.
No takes yet. Share an insight, caveat, or question.
Kunkel et al. (2011) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: