Answers are grounded in this paper and cite their sources.
Results of some geometrical studies of normal stress effects in a parallel plate instrument have been discussed. The parallelism and the concentricity of two plates are necessary conditions for the quantitative measurement. The rotational velocity of a cup should be kept below about 70 rpm for the apparatus with the cup radii about 6∼8 cm. to avoid the influence of the centrifugal force. Accesses of manometer tubes with the diameter about 2 mm. cause no appreciable disturbances. The influence of side gap may also be neglected. With these experimental remarks, the normal stresses are obtained as a function of the rate of shear. The applicability of the concentration-temperature superposition procedures has been tested with the data obtained here. They are partly valid in some limited range of variables.
No takes yet. Share an insight, caveat, or question.
Tamura et al. (1959) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: