Answers are grounded in this paper and cite their sources.
A long-term wear test was performed on Kinemax and Kinematic (Howmedica Inc.) knee bearings on the Durham six-station knee wear simulator. The bearings were subjected to flexion/extension of 65-0 degrees, anterior-posterior translation of between 4.5 and 8.5 mm and a maximum axial load of 3 kN. Passive abduction/adduction and internal/external rotation were also permitted, however, two of the stations had a linkage system which produced +/- 5 degrees active internal/external rotation. The bearings were tested at 37 degrees C in a 30 per cent bovine serum solution and the test was run to 5.6 x 10(6) cycles. The bearings from stations 2 and 3, and stations 4 and 5 were swapped during the test to investigate the effects of interstation variability. The average wear rate and standard error was 3.00 +/- 0.98 mg/10(6) cycles (range 1.33-4.72 mg/10(6) cycles) for the Kinemax bearings and 3.78 +/- 1.04 mg/10(6) cycles (range 1.87-4.89 mg/10(6) cycles) for the Kinematic bearings. There were no significant differences in wear rates between the different bearing designs, the addition of active internal/external rotation or a change of stations. However, the wear tracks were different for the two types of bearings and with active internal/external rotation. The wear rates and factors were generally lower than previously published in vitro wear results; however, this may have been due to a difference in the axial loads and lubricants used. The appearance of the wear tracks with active internal/external rotation was comparable with those seen on explanted knee bearings.
No takes yet. Share an insight, caveat, or question.
Ash et al. (2000) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: