Answers are grounded in this paper and cite their sources.
The water‐related chemical parameter that affects dislocation creep in quartzite has been determined from variations in sample strength and microstructure with chemical environment in buffered deformation and hydrostatic annealing experiments. Samples were weld‐sealed in double capsules; , , and were buffered using solid oxygen buffers, AgCl or CO2. Black Hills quartzite was deformed at 900°C and 1.5 × 10−5s−1. Two samples were deformed at ∼1700 MPa confining pressure at constant and , with and varying over 8 and 15 orders of magnitude, respectively. Both samples deformed by climb‐accommodated dislocation creep with flow stresses of 300 MPa. Two additional samples were deformed at ∼700 MPa at constant lower than for the 1700‐MPa samples, with varying over 2 orders of magnitude. Both samples faulted with a peak strength of ∼800 MPa. These four experiments suggest no dependence of dislocation creep strength on , or ; instead, a strong dependence of strength on is inferred. Previously deformed samples of Heavitree quartzite were hydrostatically annealed for 4 days at 800°C and 1200 or 500 MPa confining pressure, varying and over 2.5 and 1 order of magnitude, respectively. The microstructures of these samples show increased rates of dislocation climb and grain boundary migration with increasing but no dependence on . These buffered experiments indicate that dislocation creep is affected by alone and suggest that the exponent for the term in the power law creep flow law is >2.
No takes yet. Share an insight, caveat, or question.
Post et al. (1996) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: