Answers are grounded in this paper and cite their sources.
PURPOSE: This study evaluated the effect of surface treatment of zirconia in pre-sintered and post-sintered stages on its surface roughness, phase transformation, and biaxial flexural strength (BFS). METHODS: particles, Group 2 (n=16); silica coating using Rocatec soft, and Group 3 (n=8); a control group receiving no surface treatment). Groups 1 and 2 were divided into two subgroups each according to the stage in which the surface treatment was performed (Subgroup A; surface treatment performed in the pre-sintered stage and subgroup B; surface treatment performed in the post-sintered stage). Surface roughness, phase transformation, and biaxial flexural strength (BFS) were later assessed. Data was then analyzed using two-way ANOVA and Tukey post-hoc tests at a significance level of p≤0.05. RESULTS: Subgroups treated in the pre-sintered stage showed higher mean Ra in μm (1.81±0.36) when compared to the subgroups treated in the post-sintered (0.68±0.07) stage and the control group (0.51±0.10) (p≤0.05). The pre-sintered treated group and the control showed no monoclinic phase while the post-sintered group showed significantly higher portions of monoclinic phase. Regarding BFS the post-sintered treated group had statistically significant higher values in MPa (1228±81) when compared to the pre-sintered treated group (940±101) and the control (1019±82) (p≤0.05). CONCLUSIONS: Air abrasion in the pre-sintered stage might be a promising surface treatment method to produce promising surface roughness values of zirconia without subjecting it to early degradation.
No takes yet. Share an insight, caveat, or question.
Ebeid et al. (2017) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: