Answers are grounded in this paper and cite their sources.
Abstract 3D printing offers efficiency and design flexibility in construction, but its sustainability is limited by the carbon footprint of cement-based materials. In this sense, the present study proposes hybrid printable matrices with Portland cement (30%–50%), fine earth (50%–70%), and fly ash (0–10%). Hydration and rheology of pastes were analyzed using isothermal calorimetry, thermogravimetric analysis (TGA), and rheometry, while printable mortars were evaluated using a flow table, cone penetration, and uniaxial compression. Environmental performance was assessed through cradle-to-gate life cycle assessment (LCA). Cone penetration tests showed that increasing earth from 50% to 70% raises the structuration rate from 8.6 to 33.1 Pa/min, enhancing buildability but narrowing the open time. Fly ash mitigated this effect by reducing structuration and extending open time. In compression, increasing the mass fraction of earth from 50% to 70% reduced the strength from 19.2 MPa to 5.6 MPa. The mixture containing 60% earth and 10% fly ash achieved 10.7 MPa, showing improved strength at equivalent cement content. Regarding environmental impacts, the climate change potential decreased from 355.1 kg CO₂eq/m 3 (50% earth, 50% cement) to 243.1 kg CO₂eq/m 3 (60% earth, 30% cement, and 10% fly ash), 32% lower and below the 500–583 kg CO₂eq/m 3 reported in the literature for printable mortars. These findings show the potential of earth–fly ash–cement hybrid matrices for eco-friendly, 3D printable mortars with balanced rheological, mechanical, and environmental performance.
No takes yet. Share an insight, caveat, or question.
A 2025 study studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: