Answers are grounded in this paper and cite their sources.
PURPOSE: To biomechanically compare the stability of the coracoid process after an anatomic double-tunnel technique using two 4-mm drill holes or a single-tunnel technique using one 4-mm or one 2.4-mm drill hole. METHODS: For biomechanical testing, 18 fresh-frozen cadaveric scapulae were used and randomly assigned to one of the following groups: two 4-mm drill holes (group 1), one 4-mm drill hole (group 2), or one 2.4-mm drill hole (group 3). After standardized coracoid drilling, load was applied to the conjoined tendons at a rate of 120 mm/min and ultimate failure load, along with the failure mode, was recorded. RESULTS: There was no significant difference between groups regarding load to failure. Mean load to failure in group 1 was 392 N; group 2, 459 N; and group 3, 506 N. The corresponding P values were .55, .74, and .20 for group 1 versus group 2, group 2 versus group 3, and group 1 versus group 3, respectively. However, the failure mode for the group with one 4-mm drill hole and the group with two 4-mm drill holes was coracoid fracture, whereas the group with one 2.4-mm drill hole showed 5 tears of the conjoined tendons and only 1 coracoid fracture (P = .015). CONCLUSIONS: Although there was no significant difference regarding load-to-failure testing between groups, the failure mechanism analysis showed that one 2.4-mm drill hole led to less destabilization of the coracoid than one or two 4-mm drill holes. CLINICAL RELEVANCE: Techniques with small, 2.4-mm drill holes might decrease the risk of severe iatrogenic fracture complications.
No takes yet. Share an insight, caveat, or question.
Martetschläger et al. (2016) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: