Answers are grounded in this paper and cite their sources.
Silver nanostructured films were produced by supersonic jet deposition of nanoparticles generated by laser ablation of microparticle aerosols (LAMA). The nano- and microscale morphologies of films were investigated and the electrical conductivities of films were measured in the as-deposited state and after annealing at temperatures from 100 to 400 °C. Scanning electron microscopy (SEM) and x-ray diffraction (XRD) were used to analyze the film morphologies and the grain sizes within the films. These analyses showed that the as-deposited grain size was 14–24 nm and the relative film densities ranged from 60% to 80%, depending on processing conditions. As a result of the extremely fine grain size and the lack of organics present on the surface of the grains within the films, the annealing temperatures required to achieve reasonable conductivities (20%−50% of bulk) were reduced dramatically compared to films produced from suspensions. For example, the grain size in the films began to increase at annealing temperatures of as low as 100 °C, and the corresponding conductivity was greater than 25% of the conductivity of bulk silver. Increases in annealing temperature resulted in greater coarsening and further increases in conductivity. Calculations showed that increases in conductivity during annealing at temperatures less than 400 °C resulted primarily from grain size coarsening rather than densification.
No takes yet. Share an insight, caveat, or question.
Huang et al. (2007) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: