Very fast transient overvoltages in GIS with compressed SF/sub 6/-N/sub 2/ gas mixtures

This paper discusses the characteristics of very fast transient overvoltages (VFTO) in SF/sub 6/-N/sub 2/ gas mixtures at different percentages of SF/sub 6/. A comparison of the VFTO characteristics of pure SF/sub 6/ with those of pure N/sub 2/ is also presented. The investigations are performed using a laboratory model GIS bus duct having a test gap used for simulating a switching event leading to the generation of VFTO. A capacitive voltage sensor is used to measure the VFTO peak magnitude and temporal characteristics. Measurements were carried out at two different gap spacings (0.20 and 0.61 mm) over a pressure range of 100 to 500 kPa. VFTO characteristics for N/sub 2/, SF/sub 6/ and SF/sub 6/-N/sub 2/ mixtures obtained from the experiments show similar trends. The level of surge peak magnitude is <2.0 pu for all cases when the gap was 0.20 mm, but it reaches a maximum of 2.41 pu at 0.61 mm gap. At 0.20 mm gap, in SF/sub 6/-N/sub 2/ mixtures, the difference in peak magnitudes is not significant for 10% and 20% SF/sub 6/ mixtures (between 200 and 400 kPa) and also for pure SF/sub 6/ and 40% SF/sub 6/ (between 200 and 300 kPa). The occurrence of corona stabilization during breakdown of the gap may be the cause for such a behavior. Unlike the above observations at 0.20 mm gap, at 0.61 mm gap, the peak magnitudes strictly increase with pressure for the pure gases and gas mixtures. At 0.20 mm gap, the time to breakdown of the gap is found to be almost constant in all cases. But at 0.61 mm gap, the time to breakdown is seen to be dependent on the mixture, pressure, and breakdown voltage, and this observation is in accordance with Toepler's spark law.