Answers are grounded in this paper and cite their sources.
This paper aims to study the feasibility of reducing shell wall thickness of zinc (Zn) shell casting using three-dimensional printing. Experimentation started from the design of benchmark, printing of shells at different thicknesses, followed by supporting the shells with dry, green and molasses sands. Prototypes of Zn were produced at different shell thicknesses of moulds cavities. Cooling curves were drawn to explore the cooling rate/solidification rate of molten Zn metal in hybrid shells of different thicknesses. The dimensional accuracy of castings produced was measured with coordinate measuring machine and some mechanical properties of castings were also tested to observe the effects of sand properties over the prototypes produced, when casted with shells of different thicknesses from 12 to 1 mm. It has been observed that it is feasible to reduce shell wall thickness recommended from 12 to 1 mm. While comparing hardness of the specimens produced, it was observed that the hybrid casted component with green sand shows more hardness in comparison to components casted with dry and molasses sand. Results also indicate that hybrid casted prototype with green sand at 3 mm shell thickness shows better dimensional accuracy and mechanical properties.
No takes yet. Share an insight, caveat, or question.
Lal et al. (2011) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: