Answers are grounded in this paper and cite their sources.
• Supercritical CO 2 extraction of dried Chlorella vulgaris microalgae and a parametric study was carried out. • Extraction time increased oil yield due to the higher dissolution power of oil by the supercritical fluid, which can diffuse in the cell matrix and break the cell wall. • Increasing Supercritical CO 2 pressure up to 26 MPa increases the yield due to an increase in supercritical density and thermal diffusivity. Oil yield improved to 40 %, with an increase in the reaction temperature from 30 °C to 35 °C due to a reduction in oil viscosity and diffusion resistance. • The Sovová mass transfer model successfully described both the Constant Extraction Rate (CER) and Falling Extraction Rate (FER) periods with high accuracy (R² > 0.98) for extraction of oil. • Design of experiment involving response surface methodology and model fitting with a quadratic equation was adopted due to close agreement in R 2 , R 2 adjusted, and R 2 predicted. Microalgae Chlorella vulgaris is one of the potential feedstocks for fuel generation due to its high lipid content, rapid growth, easier cultivation and adaptability to the environment. In this work, Chlorella vulgaris microalgae were selected as the feedstock for the extraction of oil using supercritical CO 2. The effects of temperature, pressure, and extraction time on oil yield were investigated in parametric research. Extracted oil yield over time was further analyzed by the full Sovová mass transfer model, describing both the constant extraction rate (CER) and falling extraction rate (FER) periods effectively. Sovová model with high R 2 and low residual error showed a close agreement between predicted and observed values of oil extraction yield. Process parameters were fine-tuned using Central Composite Design (CCD) and Response Surface Methodology (RSM). High R 2 and R 2 adj values confirmed the effectiveness of a quadratic model in describing the effects of both single and interaction variables. Analysis of variance (ANOVA) study revealed that temperature, the interactive effect between temperature and time, and pressure and time have a significant effect on extraction yield due to their lower p-value. ANOVA validated the accuracy of the model due to its lower coefficient of variation. A close agreement in predicted yield of 42.85 wt% and an actual yield of 41.94 wt% was observed at optimized conditions of 32.6 °C, 25.4 MPa, and 130.2 min. Other fatty acids, including 23.73 % linoleic acid and 55.8 % oleic acid, were detected by HPLC analysis. The oil is found to be suitable for the production of biodiesel due to its high iodine and saponification values, along with low acid values. Chlorella vulgaris has the potential to be a feasible and scalable feedstock for renewable energy applications. Also, extraction involving SC CO 2 and its optimisation involving the RSM method showed an effective and statistically sound method for algal oil extraction.
No takes yet. Share an insight, caveat, or question.
Nayak et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: