Answers are grounded in this paper and cite their sources.
Lignocellulosic rectangular sheets (200 mm wide, 300 mm long and 1 mm thick), made from banana microfibres, were treated using an in-house resource-efficient one-pot system, which involves the one-of-a-kind dual and sequential processes of green bleaching and acid treatment. The purpose of this treatment was to make the lignocellulosic sheets suitable as water filtration membranes. To promote a cleaner production of the lignocellulosic sheets with no chemicals, both processes were conducted biologically using a common fungus, Aspergillus niger. This is another singularity of the study, as these processes are not known to have been run sequentially and from the same microorganism. The techno-economic analysis done showed that the proposed one-pot system is sustainable. Moreover, the results in this study confirmed that the biological process occurred, through the detection of the enzyme produced. A chemical composition analysis validated that amorphous constituents (lignin, pectin and hemicellulose) were removed to a high extent (40 – 50 %), thereby causing an enhanced cellulose content of 66 – 77 % (an increase of 30 %). Furthermore, the developed one-pot process allowed a reproducible decrease in pore size (58 %), giving the microfibre sheet a higher salt rejection capacity. Additionally, the banana microfibre sheets exhibited a high porosity of 98 % and a high water flux (460 – 1350 L/h m 2 bar), comparable to commercial membranes (around 1000 L/h m 2 bar). Furthermore, despite the expectation that the one-pot process would only maintain the mechanical strength, it caused an increase of 95 % in the wet tensile strength of the banana microfibre sheets while causing a maximum boost of 21 % in the dry tensile strength. Thus, the identified optimum conditions were acidic bleaching (pH: 3 – 5) and acid treatment of 8 days. In summary, following the one-pot process, the banana microfibre sheets were observed to be suitable for use as water filtration membranes due to their enhanced characteristics of the microfibre sheets. The one-pot system has resulted in an effective, cost-effective and eco-friendly process for successfully bleaching and acid-treating microfibre sheets.
No takes yet. Share an insight, caveat, or question.
Emrith-Jankee et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: