Answers are grounded in this paper and cite their sources.
LATEX compounds are purchased either on the basis of total solids content or the so-called dry rubber content. The total solids probably furnish a more reliable basis of evaluation, as the determination can be made with a high degree of accuracy. The dry rubber content is not a precise determination, as the proteins, fatty acids, and other non-rubber constituents are included, and in the case of compounded latices some of the compounding materials are included in the value and some are not. Hauser (8) and Noble (9) include in their books useful chapters on testing latex. Total Solids The total solids are determined by weighing about 2 grams of the sample in a low covered weighing dish about 6.25 cm. (2.5 inches) in diameter on an analytical balance. A metal weighing dish is preferred for more rapid drying. Tinned 60-ml. (2-ounce) ointment cans are satisfactory and so inexpensive that they may be thrown away if they are at all difficult to clean. The sample is dried, preferably in a vacuum oven. The temperature may be increased to 120° C. in a vacuum without any apparent oxidation or deterioration of the rubber. A sample of normal latex may be completely dried in about 10 minutes if the drying arrangement is right. Results are accurate to better than 0.1 per cent. Methods involving the use of specific gravity are worse than useless when applied to preserved latex as a concentration control. Even in the case of unpreserved, unwatered normal latex on the plantations, the hydrometers must be calibrated especially for the latex from the estate on which they are to be used.
No takes yet. Share an insight, caveat, or question.
DB Fowler (1937) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: