Answers are grounded in this paper and cite their sources.
Two series of α-1,3-glucan- graft -poly(L-lactide)(PLA) copolymer samples were prepared to elucidate how PLA chain length (DP) and degree of substitution (DS) affect seawater degradation: a DS varied series with similar DP values (DP ≈ 4, DS = 1.17-1.92) and a DP varied series with similar DS values (DS ≈ 1.9, DP = 4.2-14.2). Seawater immersion tests showed that, at similar DS values, the residual weight of the short DP film (DP = 4.2) decreased to 60% after 75 days, whereas the long DP films (DP = 6.1 to 14.2) showed negligible weight loss. At similar DP values, lower DS accelerated degradation: the DS = 1.17 film was completely degraded after 75 days, while the DS = 1.58 and 1.92 films retained 40% and 60% of their initial weights, respectively. Buffer immersion tests showed that long DP films showed no obvious degradation, whereas among DP≈4 samples, degradation became slower as DS increased, the DS = 1.17 film decreased to 35% residual weight after 75 days. This trend was consistent with water absorption behavior, long PLA side chains suppressed water uptake to less than 5%, whereas the short DP, low DS film absorbed more than 120% water after 7 days, suggesting that higher water uptake facilitates hydrolysis in short DP, low DS films. These results indicate that the rapid degradation of low DS short DP films in seawater results from the combined effects of hydrolysis and microbial degradation. In contrast, long DP films showed no obvious hydrolysis in buffer solution, whereas molecular weight decrease was observed after natural seawater immersion, suggesting a contribution from the marine microbial environment.
No takes yet. Share an insight, caveat, or question.
Su et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: