Answers are grounded in this paper and cite their sources.
BACKGROUND: Marginal hard tissue defects present at implants with a rough surface can heal with a high degree of bone fill and osseointegration. The healing of similar defects adjacent to implants with a smooth surface appears to be less predictable. OBJECTIVE: The aim was to compare bone healing at implants with turned or rough surface topographies placed in self-contained defects using either a submerged or non-submerged installation technique. MATERIAL AND METHODS: Six dogs were used. Three months after tooth extraction four experimental sites were prepared for implant installation in both sides of the mandible. The marginal 5 mm of the canal prepared for the implant was widened. Thus, following implant placement a circumferential gap occurred between the bone tissue and the implant surface that was between 1 and 1.25 mm wide. In each side of the mandible two implants with a turned surface and two implants with a rough surface were installed. The implants in the right side were fully submerged, while a non-submerged technique was applied in the left side. The animals were sacrificed 4 months later, block biopsies of each implant site were dissected and ground as well as paraffin sections were prepared. RESULTS: The marginal defects around rough surface implants exhibited after 4 months of healing substantial bone fill and a high degree of osseointegration following either the submerged or the non-submerged installation technique. Healing at turned implants was characterized by incomplete bone fill and the presence of a connective tissue zone between the implant and the newly formed bone. The distance between the implant margin (M) and the most coronal level of bone-to-implant contact (B) at implants with a rough surface was 0.84+/-0.37 mm at submerged and 0.90+/-0.39 mm at non-submerged sites. The distance M-B at implants with a turned surface was 3.39+/-0.52 mm at submerged and 3.23+/-0.68 mm at non-submerged sites. The differences between the rough and turned implants regarding the length of distance M-B were statistically significant (paired t-test). CONCLUSION: Osseointegration at implants placed in sites with marginal defects is influenced by the surface characteristics of the implant.
No takes yet. Share an insight, caveat, or question.
Botticelli et al. (2005) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: