Answers are grounded in this paper and cite their sources.
The method described uses lateral mechanical vibration at resonance. This is a modification of a basically standard method, which allows variations in modulus with dynamic stress to be studied in highly non-linear material. The test sample size is nominally 0.3 m*0.03 m*3*10 -4 m, and the method is suitable for comparative measurements on samples with consistent geometry, for which the repeatability is around 2%. It is believed to be superior, in repeatability and in the lower limit of stress at which the modulus can be measured, to the static bending method. The vibrating sample fits inside a vacuum chamber to reduce atmospheric damping, and results are not dependent on pressure below 70 Pa. Problems encountered experimentally and in the interpretation of results caused by the phenomenon of jump resonance are discussed briefly.
No takes yet. Share an insight, caveat, or question.
Radley et al. (1981) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: