Answers are grounded in this paper and cite their sources.
Electrically programmable nonvolatile photonic switches offer near-zero standby power for reconfigurable photonic integrated circuits but require a low-loss and efficient electrical programming interface. Here, we demonstrate Sb2Se3-on-silicon photonic switches programmed by a transparent indium tin oxide (ITO) microheater with a resistance of ∼74 Ω. Microring measurements show approximately linear length-dependent nonvolatile tuning, with excess-loss coefficients of 0.0013 and 0.012 dB·μm–1 for the amorphous and crystalline states, respectively. A nonvolatile Mach–Zehnder interferometer switch achieves an ∼1 dB insertion loss and a crosstalk below −17.29 dB over 1540–1560 nm. Preliminary quasi-analog programming yields 67 resolvable transmission steps over a tuning range exceeding 18.64 dB under the present measurement conditions. A π/2 phase-biased interferometric design further reduces the required phase swing and phase-change material interaction length. These results establish a proof-of-concept Sb2Se3/ITO electrical programming platform for low-loss nonvolatile silicon photonics, while further optimization of cycling endurance and programming energy is required for robust large-scale programmable photonic circuits.
No takes yet. Share an insight, caveat, or question.
Niu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: