Answers are grounded in this paper and cite their sources.
More steel scrap from recycling is being used as a raw material during steel production. It is known that residual elements arising from the scrap can affect the microstructures and mechanical properties of the final steel product. In this paper, residual elements Cu, Ni, Cr and Sn have been added to a low carbon packaging steel to determine the influence on microstructure development through processing and the final mechanical properties. Approximately 25% low quality scrap content as feedstock has been considered, giving maximum Cr, Ni and Cu residual contents of 0.15 wt% and maximum Sn content of 0.03 wt%. A Taguchi 2-level 4 factor L8 matrix has been used to consider the influence of different residual elements. When the coiling temperature after hot rolling was 600°C the residual elements affected the CCT diagram and hence hot band microstructures with varying levels of polygonal ferrite and bainite/acicular ferrite were observed. However, when the coiling temperature was 700°C, the influence of residuals was less significant with polygonal ferrite microstructures observed except for the steel with the highest residual content where some bainite/acicular ferrite was present. The presence of residual elements and/or large bainite/acicular ferrite grains retard recrystallisation after cold rolling meaning a few unrecrystallised elongated grains were observed in the final annealed product. The final products showed tensile strength ranges from 362 to 401 MPa (hot coiled at 600°C) and 394 to 414 MPa (hot coiled at 700°C.) Similar elongation values were seen for the base composition packaging steels (23.8 / 23.4% for 600 / 700°C coiling). The steel with the highest residual content showed the highest strength values in both cases, due to differences in grain size, solid solution strengthening and dislocation density, but reduced the elongation (20.7 / 16.5% for 600 / 700°C coiling). Overall, the influence of the level of residuals studied on the hardness, mechanical strength and local formability (stretch bend performance) is relatively small. This is due to the high level of cold reduction (>85%) followed by annealing resulting in a similar final product microstructure of predominantly equiaxed ferrite despite the different hot rolled microstructures.
No takes yet. Share an insight, caveat, or question.
Li et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: