Answers are grounded in this paper and cite their sources.
The effects of applied pressure and NaOH concentration on the densification behavior, structural evolution, and mechanical properties of amorphous silica during cold sintering were investigated. Increasing the applied pressure promoted densification, whereas excessive pressure accumulated residual strain, which may have contributed to anisotropic dimensional change and microstructural damage during drying. Increasing the NaOH concentration enhanced densification, reaching a maximum relative density at 5 M. Higher concentrations led to premature pore closure and limited further densification. FT-IR and Raman analyses indicated rearrangement of the SiO 2 network and an increase in hydroxyl-containing species with increasing NaOH concentration, while the overall silica framework was largely preserved. The increased amount of water removed at higher NaOH concentrations may enhance drying shrinkage and associated microstructural damage. These results indicate that both densification during cold sintering and structural evolution during drying contribute to the final mechanical properties of cold-sintered amorphous silica.
No takes yet. Share an insight, caveat, or question.
Yamaguchi et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: