Answers are grounded in this paper and cite their sources.
CO 2 hydrogenation to methanol (CH 3 OH) is widely accepted to proceed through two parallel reactions: (i) CH 3 OH formation and (ii) the reverse water gas shift (RWGS) reaction to CO. The latter reaction causes the loss of CH 3 OH selectivity. Our spatially resolved analysis of rates of product formation over a classical CuZnAlO x catalyst in a broad range of CO 2 conversion degrees (from 0 to 90% of equilibrium conversion) suggests revisiting this concept. In comparison with the RWGS reaction, CH 3 OH decomposition to CO mainly contributes to the loss of CH 3 OH selectivity with a rising degree of CO 2 conversion. Separate CH 3 OH decomposition tests in a broad range of experimental conditions proved that this side reaction is accelerated by H 2 O but negatively affected by H 2 and rising total pressure. Moreover, the decomposition should occur on other sites rather than those participating in CH 3 OH synthesis from CO 2 and can be practically suppressed above certain partial pressures of CH 3 OH and H 2 O due to site saturation. The sites responsible for the hydrogenation of CO 2 to CH 3 OH, however, are not saturated. Thus, this product can be further produced in downstream catalyst layers. As this concept is valid for several CuZn-based catalysts, we provide fundamentals for the design of selective CH 3 OH synthesis catalysts and for optimizing reaction conditions. Operating under conditions, where the undesired CH 3 OH decomposition reaction is hindered, enabled us to achieve 93% CH 3 OH selectivity at 19% CO 2 conversion (55% equilibrium conversion) at 50 bar and 200 °C using a feed with the ratio of H 2 /CO 2 of 3.
No takes yet. Share an insight, caveat, or question.
Ortner et al. (2022) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: