Answers are grounded in this paper and cite their sources.
We report here the elemental composition of sinking particles in sediment traps and in the water column following 4 artificial mineral dust seedings (representing a flux of 10 g m−2) in mesocosms, simulating dry or wet dust deposition into oligotrophic marine waters. These data were used to examine the rates and mechanisms of total mass, particulate organic carbon (POC) and elemental (Al, Ba, Ca, Co, Cu, Fe, K, Li, Mg, Mn, Mo, N, Nd, P, S, Sr and Ti) transfer from the surface to the sediment traps after dust deposition. The dust additions were carried out with fresh or artificially aged dust (i.e. enriched in nitrate and sulfate by mimicking cloud processing) for various biogeochemical conditions, enabling us to test the effect of these parameters on the chemical evolution and settling of dust after deposition. Whatever the type of seeding (using fresh dust to simulate dry deposition or artificially aged dust to simulate wet deposition), the dust was predominant in the particulate phase in the sediment traps at the bottom of mesocosms and within the water column during each experiment. 15% of initial dust mass was dissolved in the water column in the first 24 h after seeding. For artificially aged dust, this released fraction was mainly nitrate, sulfate and calcium and hence represented a significant source of new N for the marine biota. Except for Ca, S and N, the elemental composition of dust particles was constant during their settling, showing the relevance of using interelemental ratios, such as Ti/Al or Ba/Al as proxy of lithogenic fluxes or of productivity. After 7 days, between 30 and 68% of added dust was still in suspension in the mesocosms depending on the experiment. This difference in the dust settling was directly associated to a difference in POC export, since POC fluxes were highly correlated to dust lithogenic fluxes signifying a ballast effect of dust. The highest fraction of remaining dust in the mesocosm at the end of the experiment was found when the lowest chl a increase was observed, and inversely. This suggests a high interaction between a fertilizing effect of dust, a ballast effect, and POC fluxes. Our data emphasize a typical ratio Lithogenic/POC fluxes around 30 which could be used as reference to estimate the POC export triggered by wet dust deposition event. The elemental fluxes associated to the dust settling presented in this paper constitute also an original database on the export of atmospheric metals in a case of dry or wet dust deposition event.
No takes yet. Share an insight, caveat, or question.
Desboeufs et al. (2014) studied this question.