Answers are grounded in this paper and cite their sources.
We prepared five pairs of hydrogenous and deuterated ring polystyrene samples over a wide range of molecular weights (10 kg/mol ≤ M w ≤ 400 kg/mol) and investigated their chain conformations in bulk by small-angle neutron scattering (SANS) measurements. From the SANS profiles obtained, we estimated the radii of gyration R g of the ring polymers by the Guinier approximation. R g can be related to the degree of polymerization N as R g ∼ N 0.47 . This scaling exponent ν = 0.47 ± 0.01 is evidently smaller than that for the Gaussian chains (ν = 0.50) but higher than previous experimental reports (ν = 0.42–0.43). Then our data were compared with various simulation and experimental data by introducing the entanglement degree of polymerization N e for linear polymers as a normalized parameter. R g of three smaller rings, i.e., R-10, R-30, and R-70, where the numbers denote molecular weights in kg/mol unit, are in good agreement with simulation results, while two larger rings, R-100 and R-400, exhibit higher R g values than the simulations. Considering that the latter two higher molecular weight samples include maximum 3% of linear contamination, their effects on chain dimension were calculated. As a result, it has been confirmed that 3% of linear contaminations can overestimate R g of rings as much as 6% for R-100 and 12% for R-400. Thus, R g for pure large rings should be considerably lower than the present experimental values. We conclude Flory’s exponent v in R g ∼ N v for rings may not be constant but rather show molecular weight dependence due to their topological constraint.
No takes yet. Share an insight, caveat, or question.
Iwamoto et al. (2018) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: