Answers are grounded in this paper and cite their sources.
In this study, the effects of dry, liquid coolant and LN2-based cryogenic cooling applications on cutting temperatures at 50,100,150 m/s cutting speeds and 1,2,3 μm/dev feed rate were compared in micro-milling of Ti6Al4V alloy . At different parameters, internal and workpiece-cutting edges cryogenic (wacec) micro-milling cutting zones are simulated temperatures were observed. Cryogenic cooling, dry and liquid coolant applications perceived that tool wear, chip formation, strain, stresses, and shear forces interpreted with the FEM. Also, a mesh model based on Arbitrary Lagrangian-Eulerian (ALE) simulations and the Johnson-Cook Plasticity model for material plasticity failure criterion are used in this study. As a result, indicated that at the cutting velocity of 100 m/min, cryogenic cooling on the workpiece and cutting edges has caused into decreasing %57 of cutting temperature also by %54 lower tool wear was observed on the internal tool cryogenic, by %15 the shear stresses decrease on wacec in comparison with the dry cutting.
No takes yet. Share an insight, caveat, or question.
Oymak et al. (2021) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: