Answers are grounded in this paper and cite their sources.
Hydrogen fuel produced through photoelectrochemical (PEC) water splitting provides a sustainable solution for the depletion of non-renewable resources and adverse environmental effects. Cuprous oxide (Cu 2 O) shows considerable promise for water splitting photocatalyst owing to its advantageous characteristics and environmentally benign nature; yet its practical application is constrained by swift charge carrier recombination and photochemical instability. To address these limitations, our study employed Au as a cocatalyst on the surface of Cu 2 O. The aim was to promote charge separation, lower kinetic barriers and enhance surface reaction sites, thereby improving PEC water-splitting performance. Structural and compositional analyses verified that the incorporation of the Au cocatalyst onto the Cu 2 O photocatalyst surface was successfully achieved. The diminished photoluminescence intensity confirmed that Au cocatalyst significantly promote charge carrier separation. The oxygen and hydrogen evolution investigations demonstrated that Au cocatalyst enhanced photocatalytic activity, as indicated by reduced overpotential values of 590 mV and 100 mV to achieve a current density of 10 mA cm −2 , respectively, and diminished Tafel slope values. Photoelectrochemical analysis verified these results, attaining the highest applied bias photon-to-current efficiency value of 4.91% at 0.97 V vs. RHE, a low charge transfer resistance of 87.13 Ω, an extensive electrochemical surface area, and impressive electrochemical stability performance. These results point to a viable route for advancing Cu 2 O-based photoelectrodes toward efficient water splitting reactions.
No takes yet. Share an insight, caveat, or question.
Budi et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: