Answers are grounded in this paper and cite their sources.
To manufacture useful products with good surface quality from the sustainable Mg-4Zn/Si3N4 nanocomposites strengthened by Si3N4 nanoparticles, machining after stir casting is needed, and it has to be done economically. The Si3N4 nanoparticles could influence the machining behavior due to their abrasive properties and their ability to strengthen the alloy matrix. Multi-objective optimization of material removal rate (MRR) (a good indicator of economic production) and surface roughness (Ra) (a good indicator of quality of surface) are necessary to identify the optimal settings. This research reports the dry turning studies of vacuum stir cast Mg-4Zn/Si3N4 nanocomposites with a polycrystalline diamond turning tool. Response surface methodology (RSM)-based Box-Behnken design was used. The reinforcement (nanometre-sized silicon nitride) weight percentage, cutting speed, feed rate, and depth of cut were the input factors. Regression models for prediction of material removal rate (MRR) and surface roughness (Ra) were obtained and validated. Multi-objective optimization of MRR and Ra using Design-Expert software identified a reinforcement of 0.44 wt.% and a cutting speed of 110 m/min, a feed rate of 0.09 mm/rev, and a depth of cut of 0.16 mm as the optimal settings. The effects of the input process parameters on the MRR and Ra are also studied.
No takes yet. Share an insight, caveat, or question.
Reddy et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: