Answers are grounded in this paper and cite their sources.
Aim: The purposes of this study were to determine the influence of chemical-cure adhesives and light-cure adhesives on the stain susceptibility after debonding and the effects of different clean-up procedures on the stain susceptibility after debonding. Materials and methods: Seventy teeth specimens were randomly divided into seven groups of 10 teeth-Group 1: no bonding (control group), Group 2: bonding with light-cure adhesive, i.e. transbond XT and finishing with carbide bur after debonding, Group 3: bonding with transbond XT and finishing with carbide bur and polishing with pumice and rubber cup after debonding, Group 4: bonding with transbond XT and finishing with Sof-Lex disks after debonding, Group 5: bonding with chemical-cure adhesive, i.e. unite and finishing with carbide bur after debonding, Group 6: bonding with unite and finishing with carbide bur and polishing with pumice and rubber cup after debonding, Group 7: bonding with unite and followed by debonding and finishing with Sof-Lex disks after debonding. The color parameters were measured on spectrophotometer before bonding and after methylene blue staining following debonding and clean-up procedures. Results: Comparing each clean-up procedure in both adhesive systems, color change for Group 6 (19.59) was significantly higher than Group 3 (15.00) (p 0.05). Conclusion: Chemical-cure adhesive showed higher stain susceptibility than light-cure adhesive in all clean-up procedures. Both adhesives would show less stain susceptibility with polishing step with rubber cup and pumice.
No takes yet. Share an insight, caveat, or question.
Mane et al. (2014) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: