Answers are grounded in this paper and cite their sources.
The performance of three different numerical methods for predicting the large separated low over a hump model and its control using steady suction and techniques is investigated. Unsteady Reynolds Averaged Navier-Stokes (URANS), Detached Eddy Simulation (DES) and Delayed Detached Eddy Simulation (DDES) approaches are developed and applied to determine the proiciency of these approaches in predicting such degree of separation and assess their applicability to capture the turbulent low structures in the separated lowield. Active low control techniques are applied by means of two-dimensional slot located at x/c0.65 along the model spanwise with an opening of 0.00187c, directly upstream on the concave surface. The novelty of the present work is that the dynamic grid technique is formulated to model the repeated motion of the synthetic jet membrane instead of using the oscillating boundary conditions at the jet exit. Dynamic grid is found to be useful in providing more insight into the physical mechanism that drive the interface between the plenum low and separated boundary layer low. The numerical results obtained from the baseline and controlled cases are validated against the measurements and compared with published numerical results in terms of mean low quantities. Despite the fact that URANS and DES methods provide good agreement with the measurements for the uncontrolled and steady suction controlled cases, only DES showed the low unsteadiness, however the DDES method failed to predict the mean low quantities or the turbulent low features. The dynamic grid technique successfully simulated the cavity low, showed up the existence of two counter rotating vortices inside the plenum move up and down during the control cycle and inally energized the boundary layer in the separated low region.
No takes yet. Share an insight, caveat, or question.
Mohamed Mohamed (2017) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: