Answers are grounded in this paper and cite their sources.
SS316L steel, valued for its superior corrosion resistance, is extensively utilised in pressure vessels, control valves, and pipelines. However, its inadequate wear resistance necessitates surface enhancement. This study investigates the tribocorrosion performance of Co-Cr-W-C-Si-6 coatings deposited on SS316L via plasma-transferred arc welding (PTAW). Coatings were applied on 16 mm thick SS316L plates using Co-Cr-W-C-Si-6 alloy powder (45-120 µm), with arc current 120 A, travel speed 120 mm/min, powder feed rate 14 g/min, oscillation speed 550 mm/min, and stand-off distance 8 mm. Slurry abrasion tests, conducted per ASTM G105, revealed a tenfold improvement in abrasion resistance for PTAW-deposited Co-Cr-W-C-Si-6 coatings compared to uncoated SS316L. SEM analysis identified abrasive wear mechanisms, including abrasion, micro-cutting, and indentation, while EDS indicated reduced Co-Cr presence in worn regions. Potentiodynamic corrosion tests demonstrated comparable corrosion resistance between SS316L and Co-Cr-W-C-Si-6 coatings, with SS316L exhibiting good low-frequency impedance and a more complex phase angle response, indicative of robust passive film formation. While the Co-Cr coating excelled in wear resistance under slurry conditions, its electrochemical performance was marginally superior.
No takes yet. Share an insight, caveat, or question.
Deshmukh et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: