Answers are grounded in this paper and cite their sources.
Researchers around the world are currently still investigating the possibility of using poly(lactic acid) (PLA)/hydroxyapatite (HAp) composite as a biomaterial. However, most of the research published utilized synthetically derived hydroxyapatite (HAp) which is more expensive than natural-based HAp. Hence, this project aims to investigate the reliability in terms of mechanical properties of the PLA/fish scales derived HAp (FsHAp) biocomposite comprised of PLA and FsHAp as a filler at various compositions ranging from 10 to 40 wt%. The PLA/FsHAp composite filaments were developed through melt blending of PLA resin and FsHAp powder by a twin screw extruder. The test specimen was prepared by 3D printing of composite filament using a Creality CR 6-SE 3D printer. However, the composite with filler content above 30 % failed to convert into filament due to the inherent brittleness of PLA/FsHAp composite. Hence, the mechanical properties were only analyzed for PLA, 10 and 20 wt% of PLA/FsHAp composites. The 20 wt% FsHAp filler content displayed higher tensile and flexural properties than 10 wt% despite the reduction in impact properties. In this study, the 20 wt% also indicates a better dispersion and reinforcing effect of the FsHAp filler on the PLA matrix. Overall results concluded that the addition of natural FsHAp fillers has a direct influence on the mechanical properties of PLA/FsHAp composite with the support of FTIR and SEM analysis. The composite has the potential to be used in the fabrication of medical device implants using 3D printing technique
No takes yet. Share an insight, caveat, or question.
Jaafar et al. (2024) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: