Answers are grounded in this paper and cite their sources.
We analyze the error factors, namely erasure-before-write (EBW), erasure-after-write (EAW), Curie temperature πc variation, write-error (WE), statistical factor, and anisotropy constant, for writability in heat-assisted magnetic recording (HAMR) employing a stochastic calculation. We separate the bit error rate bER for each grain column in 2 bits of data. We focus on the mean magnetization reversal numbers per unit time π- and π+ for the magnetization reversal in the recording direction and in the opposite direction to the recording direction, respectively, and the medium writing time πmed, which is a time where the π- value is large during writing. EBW and EAW are related to the πc variation through the π- value. WE can be improved by increasing the π- and πmed values and reducing the π+ value. The increase in the grain number per bit is advantageous for reducing the bER value in terms of the statistical factor. The πmed value is increased and the π+ value is reduced by reducing the anisotropy constant. However, EAW increases due to the long πmed value. Since the influence of EAW is large in HAMR, we may not reduce the anisotropy constant in HAMR as is possible in heated-dot magnetic recording.
No takes yet. Share an insight, caveat, or question.
Kobayashi et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: