Answers are grounded in this paper and cite their sources.
This study investigates Zn2+ substituted Mg-ferrite having the compositional formula Mg(1−x)Zn x Fe2O4 ( where 0.1 ≤ x ≤ 0.6 in steps of 0.1) which is synthesized using the citrate precursor method. These synthesized samples were given heat treatment using microwave sintering (MS) and conventional sintering (CS) techniques. The XRD patterns of MS and CS samples confirm the formation of the cubic spinel structure, which is supported by FTIR spectra showing the formation of metal-oxygen bonds in the tetrahedral and octahedral sites. The average crystallite size calculated using Debye–Scherrer’s formula was found in the range of ∼24 nm to ∼29 nm for MS samples and ∼25 nm to ∼29 nm for CS samples. CS samples have larger crystallite sizes compared to MS samples. Uniform grain growth is observed from the FESEM micrographs where the average grain size ranges from ∼8.401 nm to ∼25.484 nm and ∼17.744 nm to ∼29.819 nm for MS and CS samples, respectively. VSM measurement reveals that the overall magnetic properties namely specific saturation magnetization (Ms), retentivity (Mr), coercivity (Hc), and squareness ratio (R) of MS samples are superior to CS samples. Most significantly, at x = 0.3, the MS sample possessed a higher specific saturation magnetization value (∼42.35 emu g−1) than its CS counterpart (∼39.59 emu g−1). The corresponding coercivity values at this concentration for MS and CS samples are ∼96.68 Oe and ∼59.63 Oe, respectively. Possible mechanisms underlying the different observed results have been compared and discussed for the MS and CS samples.
No takes yet. Share an insight, caveat, or question.
Salam et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: