Answers are grounded in this paper and cite their sources.
Polystyrenes carrying tert‐butyl peracrylic side groups have been synthesized by copolymerization of styrene with acrylyl chloride, partial esterification of the acid chloride units with tert‐butyl hydroperoxide, and, finally, methylation of the remaining free carboxylic groups. The weight percent of perester units varied from 0.9 to 3.4, that of methyl acrylate between 14 and 18%. These copolymers were used at 75 °C. in benzene solution for initiating the polymerization of methyl methacrylate; this second step polymerization obeys the square‐root law with respect to the initiator concentration, and is proportional to the monomer concentration. The graft efficiency, i.e. the ratio of the amount methyl methacrylate bonded as grafts to that of homopolymer, has been determined by carrying out fractionation of the several reaction products, using the precipitation method with chloroform as solvent and methanol as precipitant. The graft efficiency decreases from 1.52 to 0.77 when the monomer concentration increases from 1.91 to 7.54 mole· 1−1; it is however unsensitive to the macroinitiator concentration, unsensitive to the bulk viscosity of the reaction medium as well as to the presence of non‐solvent (methanol) in this medium. The perester‐content of the macroinitiator exerces a slight influence, the efficiency being higher when this content increases. The temperature affects strongly the efficiency ratio; this ratio increases from 0.53 to 1.11 when the temperature rises from 55 ° to 75 °C.; this effect stresses the strong influence of the nature of the radical with respect to their ability of monomer addition.
No takes yet. Share an insight, caveat, or question.
Smets et al. (1966) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: