Deformation behavior of polytetrafluoroethylene films under tensile stress at various temperatures

Deformation behavior of polytetrafluoroethylene (PTFE) films was investigated by thermomechanical analysis (TMA) under various tensile stresses (σ) up to 1.15 MPa in the temperature range from room temperature to 360°C. In the heating process above σ ≈ 0.25 MPa, a contraction of the PTFE film occurs in the melting temperature region. In the cooling process above σ ≈ 0.05 MPa, an elongation occurs in the crystallization temperature region, and above σ ≈ 0.5 MPa, it reaches 20–30% of the original length of the film. The PTFE films in the melt state above σ ≈ 0.5 MPa contract with increasing temperature up to 360°C and elongate with decreasing temperature. For the films that underwent deformation in the TMA, the crystalline orientation and the surface morphology were investigated by wide‐angle X‐ray diffraction and scanning electron microscopy, respectively. The degree of crystalline orientation in the deformed films increases with increasing σ and approaches a plateau at σ ≈ 0.4 MPa. On the surface of the deformed films, alignment of the bands and deformation of granules, which are formed by heat treatment above the melting point, are observed.