Answers are grounded in this paper and cite their sources.
Dense polycrystalline eutectics of alumina and yttrium aluminum garnet (YAG) were fabricated by hot‐pressing powders of pulverized arc‐melted buttons at homologous temperatures of 0.9 T eu –0.93 T eu (where T eu is the eutectic temperature). The eutectic microstructure of the arc‐melted buttons was retained after densification, although the grain boundaries were decorated with equiaxed grains of alumina and YAG ∼1–5 μm in size; possible causes for their formation have been discussed. A comparison of the measured strength of the polycrystalline eutectics (274 ± 61 MPa) with grain size and fracture toughness suggests that the strength‐limiting flaws are significantly smaller than the mean grain size and larger than the mean eutectic spacing.
No takes yet. Share an insight, caveat, or question.
Mah et al. (2000) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: