Answers are grounded in this paper and cite their sources.
Experimental study reveals enhanced microporosity but gravimetric measurement limits for hydrogen uptake in foamed geopolymers, suggesting rigorous buoyancy corrections are essential.
This study investigates the influence of thermal treatment and hydrothermal alkaline activation on the phase composition, textural properties, and hydrogen-related gravimetric response of metakaolin-based foamed geopolymers. The samples were heat-treated at 400°C and subsequently activated in 5 M NaOH for 30 days at either 20°C or 75°C. The materials were characterized by X-ray diffraction and low-temperature nitrogen adsorption, enabling evaluation of phase evolution and changes in N₂-accessible pore structure. Hydrogen measurements were performed using a gravimetric XEMIS-100 analyzer at 25°C up to approximately 10 bar, with an extended measurement up to approximately 25 bar for the sample exhibiting the highest BET surface area. Hydrothermal activation significantly modified the geopolymer matrix, promoted the formation of secondary sodium aluminosilicate hydrate phases, and increased the BET surface area from approximately 12 m²/g to 161 m²/g. The micropore surface area and micropore volume increased to 101.22 m²/g and 0.0481 cm³ /g, respectively, for the sample activated at 75°C. The XEMIS measurements showed a pressure-dependent apparent hydrogen uptake, with the highest values recorded for the hydrothermally activated sample. However, consistency analysis based on the measured micropore volume showed that the recorded gravimetric values exceed the amount that could be explained solely by micropore filling or true surface adsorption. Therefore, the XEMIS-derived values are reported as apparent gravimetric H₂ uptake rather than as validated excess or absolute adsorption. Because the effective displaced volume, skeletal volume, and associated buoyancy contribution were not independently quantified for the macroporous monoliths, the relative contributions of true adsorption and measurement-related effects cannot be resolved from the present dataset. The results demonstrate that alkaline post-treatment can substantially develop N₂-accessible microporosity in foamed geopolymers. At the same time, the study shows that, for highly macroporous geopolymer monoliths, conventional gravimetric measurements alone are insufficient to establish absolute hydrogen adsorption capacity without independent determination of displaced/skeletal volume and appropriate buoyancy and free-gas corrections. The main experimental contribution of this work is therefore twofold: demonstrating hydrothermally induced microstructural development and identifying the methodological constraints governing the interpretation of H₂ uptake in lightweight macroporous inorganic materials.
No takes yet. Share an insight, caveat, or question.
Łach et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: