Polyamide 6—long glass fiber injection moldings

The injection molding ability of long glass fiber reinforced polyamide pellets was studied. The injection moldable materials were produced by a melt impregnation process of continuous fiber rovings. The rovings were chopped to pellets of 9 mm length. Chopped pellets with a variation in the degree of impregnation and fiber concentration were studied. The injection molded samples were analyzed for fiber concentration, fiber length, and fiber orientation. Dumbbell‐shaped tensile bars were made to evaluate the mechanical properties. The fibers in the tensile bars had a high orientation in the flow direction and minor fiber concentration gradients were observed. The fiber lengths decreased with fiber concentration from 1.6 mm for a 2 vol% to 0.6 mm for a 25 vol% system. The tensile and impact properties increased considerably with fiber concentration. A low degree of impregnation in the pellets of the fibers resulted in somewhat lower tensile and impact properties.